【1】Product Model(Version)

Device Model: Any device that support SNMP function

【2】Description of the problem

Customer want to use SNMP function, but we don’t have any document for how to setup.

【3】Problem Processing and Root Cause

Test and finish this article, so our customer can following this manual to configure and use SNMP function

【4】Solution

4-1 Precondition

  • Download “MIB Browser” from network or check the attached file.
  • Ask HQ to get “SMB file”


  • Step by Step Instructions
  • Install MIB Browser “iReasoningsetup”

Use the MIB Browser to input the MIB file.

Input the MIB file (the attached MIB file)

The software can be used to perform SNMP Get, SNMP GetNext, SNMP GetBulk and SNMP Set Operation .In addition, it can also capture SNMP traps and SNMP packets sent by any SNMP device or program on the network, which can be used to monitor multiple SNMP devices at the same time. The operation process is described as below.

1,Run MIB Browser;

2, Enter the device IP address after address (here the my device IP is 192.168.1.108);

3, Load Mib file:

Load MIB file through the “Main menu –File- load MIBs”:

  • Enable the Trap message receiving function

Through the menu tools= > Trap Receive

Check the SNMP port and choose the protocol version. here the SNMP port is”161”; the Read community i set here is “public”; the Write community i set here is “private”; the SNMP protocol version I choosed is V2.

The trap port is 162.

  • The setting in device (The configuration in web page and local page are the same.)

Choose the SNMP version and input the parameter you set in MIB browser.

  • test

What’s more, if you want to use V3, please make sure the setting in MIB browser (the following picture1) is same as the device(the following picture2).

The end